Down The Rabbit Hole

You know when you plan on doing something, but that leads to something else and you don’t get the first thing done?

It’s now undecidedly Winter. Yes, it’s currently milder than normal for this time of year, but the weather is still rather crap and it will undoubtably get colder. As such, it’s time for the motorcycle to go into Winter hibernation. This involves a good clean and a wipe over with an oily rag, before the battery gets hooked up to the Optimate and the cover goes on to keep it snug throughout the cold months.

As the sun was shining this morning and it wasn’t pissing down with rain, I decreed that this would be the day that I would get that particular task done.

However, when I opened the garage door, the light didn’t automatically come on and the alarm keypad didn’t beep at me as it should.  It’s done this a couple of times now. I think the microprocessor gets caught in a loop and times out… no doubt due to my shoddy programming.   It’s easily fixed, just needing the RESET pin to be momentarily grounded.  I’ve faffed around doing this before… it’s a bit fiddly and I keep determining that I should fit a small switch to allow this to be done more easily.

OK, let’s get it done today.
Get it done and out of the way and then I can clean the bike.

After a quick consult with the circuit diagram, I grabbed all the bits I would need, including my somewhat expensive gas powered soldering iron – there are electrical sockets in the garage of course, but none are close enough to the alarm panel, so my likkle 15W Antex won’t reach.

Balancing atop a pair of stepladders, I fitted the switch in place then tried to solder the wires to the relevant points on the circuit board, but my iron was stone cold.  I fiddled with it and tried to start it several times, but nothing.  OK, something else that needed to be fixed.
I’d fix this, then I could fix the alarm panel and then I could clean my bike.

I brought the iron back inside and started to take it apart, but I couldn’t find anything obviously wrong. Two hours of reading various webpages and watching YouTube videos from people who’d had similar experiences suggested that impurities in the cheap gas I’d been using had led to it’s demise. I gave up with it and went to find an extension lead so I could use my electric iron instead.

I knew I had a spare one in the loft somewhere and – unusually – it didn’t take me long to find it. But, I’d forgotten that I’d taken the plug off it a few weeks back when I desperately needed one for Harry’s new telly.  D’oh!   I’ve since taken stock of some more 13A plugs, so I quickly fitted one, then went back out to the garage and modified the alarm panel.

I’ll clean the bike tomorrow.
With any luck.

4 thoughts on “Down The Rabbit Hole”

Comments are closed.