Beginners Luck

Daughter recently had new fibre broadband installed.

Once it had been done I went round the next day and moved the router, as it was in an inconvenient place. Most routers come with an ethernet cable, but it’s generally only a very short one – 1 metre – and so has to be placed near the hub… or ONT in this case.

I took my ethernet toolbag with me, which contains all the tools and connectors that I need for such a job.  I noticed that there was a length of CAT5 ethernet cable in there too, so I didn’t bother getting the reel down out of the garage loft space.

I moved the router and re-cabled the power, putting it all into some small trunking that I’d purchased earlier from a well known DIY chain that rhymes with Me & You.

Everything went smoothly until I tried putting the new connectors onto the new cable. I hadn’t realised that the length of cable I already had in the bag, was a piece of cheap and nasty rubbish. Connectorising it was a nightmare.

I managed to do one end –  after several attempts – but the other end just would not go on.  I tried and tried and tried, but each time it failed and I would have to cut two inches off the end of the cable and start again. I was cursing myself for not bringing some decent cable with me.

I was running out of connectors – and cable – and eventually decided to give up, explaining that I would come back the following day with some pukka cable and finish the job.

“Can I give it a go?” said daughter, who had been watching my futile attempts with interest.

“Fill your boots”, I said humouring her.  I have literally fitted hundreds of these connectors over the years, both for work and home. They are as fiddly as fuck to do – at the best of times – and there is a definite knack to putting them on.

I stripped a length of sheaf off the cable and passed it to her along with the colour code, whilst I went and put my tools away.

“I think I’ve done it”, she said, just a couple of minutes later. I hadn’t even finished picking up my tools.  I walked over to her and took the cable and looked at it… again, rather dismissively.

But, hold on, this actually looked to be correct. All the right coloured wires were in the right slots.  I crimped the connector and plugged it into my tester. Pressing the TEST button, I was greeted with eight glowing green LEDs, indicating a correctly wired cable.

“Is that good?”, asked Daughter. “Have I done it right?”

“Harumph…” I grumbled. “Go and make some tea”.

6 thoughts on “Beginners Luck”

    • The thing is, I didn’t teach her, Bren, she just picked it up.
      The Force must be strong within her.

Comments are closed.